Stays plugged in.

Locks at the PDU

P-Lock

Two spring tabs, the P-shaped clips on either side of the plug head, click into the latch slots of a P-Lock-ready outlet as the plug seats; pull on the cord and the tabs bear on the outlet, not the pins.

The cords · How it holds

Locks at the PDU

P-Lite

The P-Lock latch on one side of a low-profile C14 plug head whose other side is recessed, so a fingertip reaches the tab between neighbours on a fully loaded PDU.

The cords · How it holds

Locks at both ends

V-Lock

Schurter's V-Lock cord-retention system: the plug and the connector each carry a spring latch, marked with the yellow V, that clicks into the notch of a V-Lock outlet or inlet.

The cords · How it holds

Locks at the equipment

A-Lock

Spring fingers inside the connector grip the pins of any standard C14, C16 or C20 inlet as it is pushed on. The plug is a standard, non-locking plug, so the PDU side does not matter.

The cords · How it holds

Locks at the equipment

S-Lock

SSEMCO's rotary lock: a quarter turn of the grey collar on the connector body drives internal pins that pinch the inlet's pins. Fits any standard C14 or C20 inlet; the PDU side does not matter.

The cords · How it holds

Locks at both ends

Dual-Lock

SSEMCO's D-Lock: a P-Lock plug for a P-Lock-ready PDU outlet and an S-Lock rotary connector for any standard equipment inlet, on one cord.

The cords · How it holds

Locks at both ends

Z-Lock+

Zonit's Z-Lock Plus. At the PDU a low-profile locking nut, tightened after the plug is seated, clamps the plug in any standard C13 or C19 outlet. At the equipment a spring latch inside the connector grips any standard C14 or C20 inlet.

The cords · How it holds

Locks at both ends

Z-Lock

Zonit's original two-ended lock. The cords we stock carry Well Shin's locking plug (WS-003) and auto-locking connector (WS-003A): a red slider at each end, the plug gripping inside any standard outlet, the connector gripping any standard inlet.

End of life. Z-Lock+ is the current version.

The cords · How it holds

Locks at the equipment

IEC Lock

Scolmore's IEC Lock: a latch inside the C13 connector grips the earth pin of any standard C14 inlet. The plug is a standard C14.

The cords · How it holds